Proxim ORiNOCO AP-2500 Manual do Utilizador descarregar pdf (Página 203)

203

Using the Command Line Interface

NOTE

The distance between APs should not be approximated. It is calculated by means of a manual Site Survey, in

which an AP-2500 unit is set up and clients are tested throughout the area to determine signal strength and

coverage, and local limits such as physical interference are investigated. From these measurements the

appropriate cell size and density is determined, and the optimum distance between APs is calculated to suit

your particular business requirements.

Set the Multicast Rate

NOTE

The Distance Between APs must be set before the Multicast Rate.

– 3 = wireless card in Slot A

– 4 = wireless card in Slot B

[Device Name]>set wif <3 or 4> multrate <1,2,5.5,11 (Mbps)>

This feature is only available for 802.11b wireless cards.

Set Ethernet Speed and Transmission Mode

[Device Name]>set etherspeed <value (see below)>

[Device Name]>reboot 0

Set Interface Management Services

Set Communication Ports

[Device Name]>set httpport <HTTP port number (default is 80)>

[Device Name]>set telport <Telnet port number (default is 23)>

Set Session Timeouts

[Device Name]>set tellogintout <time in seconds>

[Device Name]>set telsessiontout <time in seconds>

Ethernet Speed and Transmission Mode Value

10 Mbit/s - half duplex 10halfduplex

10 Mbit/s - full duplex 10fullduplex

10 Mbit/s - auto duplex 10autoduplex

100 Mbit/s - half duplex 100halfduplex

100 Mbit/s - full duplex 100fullduplex

Auto Speed - half duplex autohalfduplex

Auto Speed - auto duplex autoautoduplex (recommended)

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 249 250

Sem comentários

Proxim ORiNOCO AP-2500 Manual do Utilizador Página 203